"> what is the general approach..." <- > <@thejpster:matrix.org> > what is the general approach to troubleshooting errors like the following. > > 0. Check your probe-run / probe-rs arguments (is the --chip FOO correct?) > 1. Check your wiring. > 2. Check your voltage rails. > 3. Get the oscilloscope out and really check are you sending SWDIO and SWCLK to the right places will have to wait till i get back to the office to check voltages and use oscope. `probe-run` exhibits the issue far more than `probe-rs-cli`. in fact, i don't think i have seen the errors when using `probe-rs-cli`. `cargo embed` shows them though. whats more, the errors pretty much only show up when im in a low cell signal area. when i move near a window or outside, the errors go away. this leads me to believe that they are coming from the 9160 modem/firmware